...
COLLECTIONS OF BOUND VOLUMES
Some collections consist of diaries or scrapbooks, etc. In this case, the "(item number)" represents one of the bound volumes, rather than a folder full of loose sheets. Volumes that are stored upright have no prefix. Their call number begins with "MS". If they are shelved flat, their call number will begin with "bMS" whether they are in a box or not, because all flat items that approximate the size of the standard flat box (11x15x3") are shelved in the same area. In this instance "b" means "boxed", but also refers to a specific area of the stacks. There is a separate section on end-processing single items that applies to end-processing such collections. The difference between a collection of bound volumes and a single item bound volume is that the single item will not have an ArchivesSpace finding aid.
BASIC PROCEDURES, WARNINGS, AND TIPS:
End-processing an upright collection.
APPLYING SELF-ADHESIVE LABELS TO ACID-FREE FILE FOLDERS
Position manuscript material away from the reinforced tab of the file folder.
Work slowly so label doesn't accidentally adhere to manuscripts.
Label should cover any penciled text on the upper left tab and sit about 1/16" below top edge
Text that might protrude should be erased before the label is affixed to avoid smearing ink.
Use white Mars plastic Staedtler erasers for folders, sweep work area frequently into wastebasket.
Be consistent with placement in a given collection, once the location is chosen.
Do not reapply spoiled labels as they can smear and eventually fall off : it is better to reprint them.
FILLING AN UPRIGHT DOCUMENT BOX
There are acid-free board "spacers" for Record Storage boxes (Paige boxes) and Document boxes (Hollinger boxes) available to prevent this from happening. There is also a thinner, a wider, and a taller version of the document box available. If you cannot slip your hand into the back of the box, it is overfull. But it is also important not to under-fill the box. The folders and their contents will start to slip and curl at the bottom if the box is not adequately full, as illustrated below.
FILLING AN UPRIGHT FILE FOLDER AND WHEN TO CREASE BOTTOM OF FOLDER
In addition to the crease along the bottom of the folder, there are some additional score lines that could be folded to adjust the thickness of the folder when necessary. If in doubt about where to crease the folder, it may be better not to crease it at all, but to ask for help. Use the guidelines below:
...
VOLUMES STORED UPRIGHT IN BOX
If volumes are too tall to stand normally inside the box, or if the bottom of the text block is flush or slightly longer than the bottom edges of the boards, let the volumes rest on their spines within the folder. If they are stored with the spines up, it will put pressure on the boards and they will eventually detach.
End processing a flat collection.
APPLYING SELF-ADHESIVE LABELS
Position manuscript material away from the upper left corner of the folder, to create a flat surface on which to rub down the label, and so as not to put pressure on the material itself. Return manuscript material neatly to its final location within the folder. Work slowly so label doesn't accidentally adhere to manuscripts.
Label should cover any penciled text on the upper left corner and sit about ¾" below top edge and about ¾" from the left (folded) edge.Text that might protrude should be erased before the label is affixed to avoid smearing ink. Be consistent with placement in a given collection, once the location is chosen. Do not reapply spoiled labels: keep a list of reprints needed.
...
KEEPING ORDER INSIDE THE FOLDER
Keep sheets as square as possible inside the folder, but do not try to pick them up and tap the edge on the table, because often they are fragile. Instead, for badly disarrayed sheets, lay them on top of each other one at a time slowly and carefully. But do this only if they are badly disarrayed or it will just waste a lot of time. Most collections probably won't even need to be neatened up. Keep the original order of the material, make sure no sheets are upside down (unless you can determine that this is part of the correct order).
Procedures, warnings and tips for Manuscript end-processor : upright collection
DOCUMENT BOXES
For upright document boxes, use archival corrugated board "spacers" boxes that are not all the way full. Document boxes come in half width, tall (12 ¾"), and wide (7"). We use the wide and tall rarely so as not to have too many different types of supplies to stock, store, and keep track of. Occasionally we use letter-size boxes, when it better suits the material. But we have only standard and half width of these. We custom make folders out of scrap for the tall document boxes, cutting them to the full height of the box.
...
UPRIGHT MANUSCRIPTS TOO TALL FOR DOCUMENT BOX
For a collection that is going to HD, use an extra tall (12 ½") Hollinger box for items that are best stored upright but do not fit into the regular size document box. DO NOT use a tall document box for HTC items that will be stored onsite, as they exceed the dimensions of the shelving. Use of the tall document box may be re-evaluated so that the number of different kinds of boxes and supplies can be minimized. In that case, we may decide to use flat boxes for those oversize items. For items that are removed from their normal sequence, the manuscript end-processor will annotate the Finding Aid Correction notebook with "shelved at end of collection" or "shelved as pf at end of collection".
Procedures, warnings and tips for Manuscript end-processor : flat collection
FITTING OUT A BOX
Here are some examples of boxes fitted out for minimal movement of contents during transport to HD. In future this level of customization may be reserved for extraordinarily fragile items. (see sample box fitted out for transport).
...
3-FLAP FOLDERS
We are using up the supply of these sturdy custom folders on collections of photographs or collections that have many small delicate pieces to be kept together. The Reading Room uses spoiled 3-flap folders to transport materials for reproduction, because they keep things from falling out. We no longer buy them because they are a bit difficult and time-consuming to fold, their thickness uses up a lot of space, and they are a bit cumbersome in the Reading Room.
Autograph files and Catchalls
AUTOGRAPH FILES
The large collections referred to thus far are mainly closed groupings of items from the same source, such as gift or bequest of a certain individual, or purchased with a particular fund. But some collections are composed of items that each have a different source. They are grouped together either because they provide examples of handwriting and signatures of famous literary figures (hence the name Autograph file), or because they are miscellaneous and unrelated (usually) single sheets.There is a rather large Autograph file at Houghton and in the Theatre Collection. They were begun in the early years of the library and we continue adding to them. Their call numbers are : "Autograph file" and "HTC Autograph file". Items in these two collections, are filed alphabetically by author. They do not have item numbers like most other collections do. We have not added barcodes to the boxes for the Autograph files because each item, within its folder, has its own item record (see: Item Records and Bar codes). The number of boxes cannot be determined by looking at the item records for these collections. If a box is added, the finding aid should be updated. That is how one would know the number of boxes on the shelf.
...