Page Comparison

Labeling single items boxed together. shelved onsite

If several consecutivel- numbered (or nearly consecutive) single items are of a similar size and fit well together, it is more effective to store them each in a folder within a box, rather than putting them all into pre-fabs and spending time making tabs and putting in donor plates, costing time and money. Items are not assigned call numbers with any regard to size, so this situation doesn’t occur that often, but it is good to take advantage of it when it does occur. Each folder, containing a distinct single item, will get a barcode, but the box goes without one. This is the only instance in which we would put a barcode on a manuscript folder. Except that of flat file drawers, where the procedure is about exactly the same.

The box label can be generated individually using the WORD box label template, as in the example below. If folders are added over time, the label should be reprinted, so it is best to keep your own copy of the document for future use.

This convention makes it easy for the Stacks staff to notice that there are multiple items in the box. The box should be shelved by the Manuscript Department Assistant / End-processor since single items are shelved differently than collections. Each time another folder is added, the box label is updated.

IMPORTANT
You will have to annotate all of the records in Alma afterwards to show that they are shelved together and each in a single folder.  The first item will be the one that records the fact that they are all shelved in a single box, and will show the linear feet.  Subsequent items will say “1 folder in 1 box, shelved with bMS Eng 1441-1447”.

Below is a sample entry from HOLLIS:

Here is how an entry appears in HOLLIS:

The holdings “shelved with” is a “z” note in the 852 field, as below:

It is possible to start a certain size box for a single item that is only 1 leaf or folder, in the expectation that there will be more single items of that size and shape that can be added to the box in the future. These “add-to” boxes are standard sizes, i.e. a 11x15” add-to box; 14x18” add-to box; 16x20” add-to box, etc. There are some advantages to storing single items in this manner.

Related storage methods and advantages/disadvantages

HTC and P&GA use flat files in much the same way that the “add-to” boxes shown here are used.  Storing like-sized items together saves on time, space and supplies. The only disadvantages are that records have to be updated to reflect location and that items within a box or drawer may not always be contiguous.  Also, shelf reading might be slightly slowed down in that a drawer or box has to be opened in order to read the barcodes that must be placed on each individual folder. However, these disadvantages are not that inconveniencing considering the saving of space and money spent on supplies.

More frequent use of add-to boxes would make it unnecessary to purchase many more heavy and expensive flat files. These take up a lot of space, are awkward and sometimes dangerous to use when retrieving and re-shelving material, and cannot be easily moved.  It is also difficult to transport material stored inside quickly in the event of an emergency. HTC sometimes stores two piles of items, which otherwise would have fit in standard size boxes, side-by-side within the drawers of a flat file meant for oversized items. These piles might be better off on a shelf in add-to boxes, if there were space for them. But this decision should be made on a case-by-case basis.