Page Comparison

Connection

a.      Connect the projector to a laptop (recommended) or a desktop with either a HDMI (recommended) or VGA cord.

Note: when using a desktop, make sure the HDMI or VGA cable is plugged in to the computer tower, not the monitor.

insert image (back of the projector showing different outlet)

b.     Connect the projector to an AC outlet. Note that there is an adapter for U.S. outlet types as the equipment was imported and is configured for foreign outlet types.

c.      Connect the camera with a MHL cable. The MHL slot is located on the back of the camera. The camera itself is powered with the MHL cable therefore no power outlet is needed.

insert image (back of camera)

 insert image (entire set up)

Driver Installation

a. Download the software "Install_DAVID-CAM-3M_Driver” from (nettemp, need to create a folder in goliath/software for permanent storage).

b. Make sure the projector and camera is set up and connected to your computer. Camera Drive can only be installed when the camera is connected to the computer.

c. Follow the instructions on screen to finish installation. It usually takes less than a minute.

 insert image (driver window)

Projector Initial Setup

1. The power button is located on the top of the projector. Press once to turn it on.
2. The projector is configured with optimal settings, it is not recommended to change anything in the menu.
   If you need to restore the recommended settings, follow the steps below: (insert image (reset menu))
   1. Select “Reset” in the menu
      
   2. Turn the “Auto Keystone” off, and set the manual value “Manual Keystone” to 0.
   3. As “Projection Location”, select the icon for desktop use, not “Auto”.
      
      
3. Adjust its focus using “focal ring” slider located on the top of the projector.(insert image (Projector focal ring picture) => also, what surface are they focusing onto?)
4. Set up the Projector as Extended Desktop in windows (insert image (windows dialogue)

1. 1. Right click on your desktop to bring up the desktop dialogue.
   2. Select “Screen resolution” (or “Properties” depending on your Windows version)
   3. Your computer should recognize the projector as the extra display. If not, check the projector's connection to the computer.
   4. On the Screen Resolution Window, under “Multiple displays”, select “Extended these displays” to extend your display to the projector.
   5. Click on “Identify” on the top right of the window dialogue to make sure your computer monitor is selected as Display “1” and the Projector is selected as “2”
   6. Click “Apply” and then “Okay” to apply all the changes made.