Page Comparison

Material options

 

METHOD	MATERIAL	COST ($/sf)	TIME: file prep (hr)	TIME: fab (hr)	TIME: assembly (hr)	TIME: total	MATERIAL RECYCLABILITY

Image Removed

3D Printing -

ZCorpgypsum-based white powder$2681134146no 3D Printing -

Polyjet

UV-cured resin

$748

11

49.5

2

62.5

no

 

	3D Printing - UPrint	extruded ABS plastic

 

$868

11

 

83.5

 

36

 

130.5

yes (special service provider)

 

	3D Printing - Dremel	extruded PLA plastic	$26	11	105	0.5	116.5	yes (special service provider)

File

preparation 

To 3D print the site model, we'll need a closed, watertight, error-free STL mesh.

1. RHINO
   1. Use the Drape command to generate a NURBS surface from the given 3D mesh of the topography.
   2. Trim the bases of the buildings with the topography, and trim the topography with the building bases.
   3. Extrude the curves for the roads and split the topography with the extrusions.
      1. Lower the road surfaces.
   4. Split the model into sections that will fit in the 3D printer.
      
       
   5. Create surfaces for the bottom of the model base. It's best to have a grid of surfaces rather than 1 large surface per section.
      
      
      
      
   6. Create meshes from every NURBS surface according to the guidelines for the 3D printer you plan to use.
      
       
   7. Working one section at a time, use the MeshRepair panel to join the top of the model to the bottom surface and to fill the gaps between the road surface and topography.
      
       
   8. When finished, use MeshRepair to check for naked and nonmanifold edges. Use the MeshRepair tools to delete the problematic mesh faces and rebuild them.
      
      
      
      
   9. Export each section to STL individually.
     DESKARTES
2. Open each section in DeskArtes and verify the mesh.
Use the Print Preparation tab to hollow and drain the model.
Image Removed

1. For ZCorp prints, set the minimum wall thickness to 0.125 inch.
4. Save each section in a new STL file.
    
BACK TO RHINO
1. Open the hollowed STL file.
2. Trim out the rest of the bottom.
   
   
    
3. Create a structural waffle about 3" on center and the same thickness as the model walls.
   
   
    
4. Use MeshRepair to check for errors and repair the meshes as necessary.
5. Export each section with its structural supports in another new STL file.
    
5. BACK TO DESKARTES
   1. Open the new STL in Deskartes and verify and repair as necessary.
       
6. SUBMIT JOB
   1. Submit each section as a separate 3D print job.

Related articles