Page Comparison

Scanning Station Components

Connection

***After you are finished with the Scanning Station please make sure all components are replaced in their respective spots. See image below.

Image Added

Setup Scanning Station

1. Position the tripod.
2. Attach the projector and camera to the red alignment guide. Note: the position of the camera and projector may be swapped depending on the size of object to scan. See Image: Projector postion
3. Secure the red alignment guide to the tripod.

Connect Hardware

a.      Connect the projector to a laptop (recommended) or a desktop with either a HDMI (recommended) or VGA cord.

Note: when using a desktop, make sure the HDMI or VGA cable is plugged in to the computer tower, not the monitor.

insert image (back of the projector showing different outlet)the provided laptop with the HDMI to Display Port DP cable and power supply cable.

Image Added

b.     Connect the projector to an AC outlet.a standard 110VAC power outlet. Note: there is an adapter for U.S. outlet types as the equipment was imported and is configured for foreign outlet types.

Connect the power cable to a power outlet.

Image Added

c.      Connect the camera with a the provided MHL cable to the provided laptop. The MHL slot is located on the back of the camera. The camera itself is powered with the MHL cable therefore no power outlet is needed.

insert image (back of camera)Image Added

 insert image (entire set up)

Installing the Camera Drive

a. Download the software "Install_DAVID-CAM-3M_Driver” from nettempt.

d. Make sure the USB key that contains the license for the software is connected to the

laptop.

c. Follow the instructions on screen to finish installation. It usually takes less than a minute.

 insert image (driver window)

Setting up the Projector

Image Added

Image Added

Initialize Projector

1. Turn the projector on. The power button is located on the top of the projector . Press once to turn it onand will turn blue once it has been pressed once.
2. The projector is delivered configured with optimal settingsettings, it is not recommended not to change anything in the menu.
   To If you need to restore the recommended settings: (insert image (reset menu)), follow the steps below:
   1. Select “Reset” in the menu
      
   2. Turn the “Auto Keystone” off, and set the manual value “Manual Keystone” to 0.
   3. As “Projection Location”, select the icon for desktop use, not “Auto”.
      
   Adjust its focus using “focal ring” slider located on the top of the projector
   1. .
   (insert image (Projector focal ring picture)
3. Set up the Projector as Extended Desktop in windows ((insert image (windows dialogue)
   Image Added
   

1. 1. Right click on your desktop to bring up the desktop dialogue.
   2. Select “Screen resolution” (or “Properties” depending on your Windows version)
   3. Your computer should recognize the projector as the extra display. If not, check and see if your projector is connected to the right spot on your computerthe projector's connection to the computer and hold-down the Windows key and tap "P".
   4. On the Screen Resolution Window, under “Multiple displays”, select “Extended these displays” to extend your display to the projector.
   5. Click on “Identify” on the top right of the window dialogue to make sure your computer monitor is selected as Display “1” and the Projector is selected as “2”
   6. Click “Apply” and then “Okay” to apply all the changes made.