Calibration

Connect the projector and camera to a computer

a.      Connect the projector to a laptop (recommended) or a desktop with either a HDMI (recommended) or VGA cord.

Note: when using a desktop, make sure the HDMI or VGA cable is plugged in to the computer tower, not the monitor.

insert image (back of the projector showing different outlet)

b.     Connect the projector to an AC outlet.

c.      Connect the camera with a MHL cable. The MHL slot is located on the back of the camera. The camera itself is powered with the MHL cable therefore no power outlet is needed.

insert image (back of camera)

 insert image (entire set up)

Installing the Camera Drive

a. Download the software "Install_DAVID-CAM-3M_Driver” from nettempt.

b. Make sure the projector and camera is set up and connected to your computer. Camera Drive can only be installed when the camera is connected to the computer.

c. Follow the instructions on screen to finish installation. It usually takes less than a minute.

 insert image (driver window)

Setting up the Projector

1. The power button is located on the top of the projector. Press once to turn it on.
2. The projector is delivered with optimal setting, it is recommended not to change anything in the menu.
   To restore the recommended settings: (insert image (reset menu))
   1. Select “Reset” in the menu
      
   2. Turn the “Auto Keystone” off, and set the manual value “Manual Keystone” to 0.
   3. As “Projection Location”, select the icon for desktop use, not “Auto”.
      
      
3. Adjust its focus using “focal ring” slider located on the top of the projector.(insert image (Projector focal ring picture)
   Set up the Projector as Extended Desktop in windows ((insert image (windows dialogue)

1. 1. Right click on your desktop to bring up the desktop dialogue.
   2. Select “Screen resolution” or “Properties” depending on your Windows version)
   3. Your computer should recognize the projector as the extra display. If not, check and see if your projector is connected to the right spot on your computer.
   4. On the Screen Resolution Window, under “Multiple displays”, select “Extended these displays” to extend your display to the projector.
   5. Click on “Identify” on the top right of the window dialogue to make sure your computer monitor is selected as Display “1” and the Projector is selected as “2”
   6. Click “Apply” and then “Okay” to apply all the changes made.