Under this page are listed all the pages that were useful to Meghan pre-installation, including her lab notebook.
Where spare parts have been put, where I am keeping system components, etc.
Laptop username: stubbs lab
password: McKay106!
Requirements for Computer
- 32 or 64-bit Windows machine
- Able to ssh in
- Software:
- ThorCam Software (LP126MU)
- Kinesis Software (PIA13, KMTS50E, MFF102)
- LabJack Software
- Hardware:
- Total # USB ports: 4 (at least one must be USB 3.0)
- 2 USB ports for KIM101 motor controllers (to control 8 piezo actuators, 4 pitch/yaw stages)
- 1 USB ports for MFF101/MFF102 optical flip mounts
- 1 USB port for alignment camera (LP126MU) - MUST BE USB 3.0
- 1 USB port for LabJack
- Ethernet port
Desk space right now is in 106D, where the desks on the right where you walk in I have taken over. Clear plastic boxes with parts from stages, lenses/mirrors/lens mounts, optics mounting, and shearing interferometry under right desk. Spare/additional parts are on shelf above computers, and on windowsill to the left of computers.
First desk drawer has writing supplies, packing slips, paper, a laser pointer, and index cards for alignment. Second drawer has tools, third has fasteners.
All components are in boxes under/around/in desks, or set up on the rightmost desk.
Lists of parts have been put in the top drawer of the desk.