...
If you want to synchronize the grasshopper slider with the smartphone and view the status, you have to use both “Parameter Change” and “Sync Parameters”. “Parameter Change”: This parameter is connected with the slider and view the status through the output “Sync Parameters”: You should create sync parameter to synchronize the slider value from smartphone and grasshopper. You can manipulate value both from both. | |
“Parameter Change” “Sync Parameters” |
|
“Track Device”: This is the parameter that can track the direction and the position of the device connected. In this workshop, it tracks your smartphone. You can check the X(red), Y(green), Z(blue) axis and a base point from the image on the right side. You can also connect the output of this parameter with “Plane (Pln)” parameter. | ||
 “Track Device" |  |
|
...