Lab Book

Wed June 15

• Met the group and learned the basics of some of the various projects
• Learned to use the coffee machine !!!
• Learned to solder and soldered right angle pins onto the wind sensors
• Set up a Mac mini

Thurs June 16

• Mapped out the wind sensing system  
• Completed online general lab safety course
• Completed online physics machine shop and Makerspace safety course
• Hooked up the hot wire anemometer to a voltmeter to test it out
  • GND-White 5
  • +9-12V -Violet 4
  • OUT - Orange 2
  • TMP - Green 3
  • SHDN - Brown 1
• Like so:
•                            
• Knotted cable is ground

Fri June 17

• Got a lesson about screws, and read more about screws
• Installed lab jack software on Mac
• Hooked up one wind sensor to the LabJack to test it out while connected to the Mac
• Cut one carbon fiber tube in half and assembled one of these sensors with stands without any adhesive. It fits well, the ribbon cord needs to be pushed in.
• Need to learn how to write code to get from the voltage numbers to