HoroI2CFPGA
PDF of schematics:
Zipped Altium source files:
Gerber files:
FPGA Verilog file:
Running the I2C testing with a minimal TipTone Arduino:
At the moment, the Arduino is only dealing with SCL and SDA, not _RST or _INT.Â
Power comes from USB, which goes out the ribbon cable.Â
Assuming the FPGA board is getting its own power, that means pins 1 and 2 should be cut on the ribbon cable, isolating the +5Vs.
The ECO wire is connecting pins 9 and 10 to ground.
Arduino code:
20230126 Here's the full archive of Lattice Diamond project HoroI2CFIFO, last updated 20220801
Copyright © 2024 The President and Fellows of Harvard College * Accessibility * Support * Request Access * Terms of Use